If there are any problems with the loading of the router, you can try to reset it to the standard settings by holding the reset button, or if there is a display, select “Restore settings” and enter the standard pin code 1234. The router will boot with the new firmware. The firmware is downloaded to the router and the status will be written “Waiting for reboot”, after which, instead of the install button, there will be a reboot button, and you will need to click it. In the list of devices (Routers/Drives) select a router, in the bottom of the list, tick the firmware to be downloaded to the router and click “Install”. Any firewall on the computer must be disabled.ĥ) When the router is disconnected from the mains, press the “reset” button and continue to turn it on, wait for about half a minute until the NetInstall program displays a new device in the device list.Ħ) In “Packages”, click the “Browse” button and specify the directory with the firmware. Click the “Net booting” button, check “Boot Server” enabled and enter the IP address from the same subnet where the computer is located, for example 192.168.88.200, its NetInstall will temporarily assign it to the router. 1) Download NetInstall from the official siteĢ) Register a static IP address to the computer, for example 192.168.88.254ģ) Connect the Ethernet cable to the router through the ETH1 port with the computer using the switch or directly.Ĥ) Run the NetInstall application.
0 kommentar(er)
